Pioneer PDP-5020FD Owner's Manual - Page 24
Mount the Flat Panel TV
![]() |
UPC - 012562887098
View all Pioneer PDP-5020FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
02 Install Your Flat Panel TV 2.4 Mount the Flat Panel TV Because your flat panel TV is slim but heavy, have at least two people mount and/or position the panel. The following sections provide instructions for the different mounting and anchoring options. Anchor the Panel When Using a Stand When using a stand, stabilize the panel to keep it from tipping over. Please use the supplied metal fittings and screws to anchor the panel to a wall or other solid support structure. Another option is to purchase hooks, cords, and fittings through your installer or from your local hardware store. The hardware size and strength depends on the composition and thickness of the anchoring surface. Recommended hook: Nominal diameter 8 mm (3/8 inch), length 12 mm to 18 mm (0.5 inches to 0.7 inches) To anchor the panel when using the provided stand, follow the steps below. 1 ) Attach the hooks to the mounting holes on the back of the panel. 2 ) Sink the fittings into the wall or support structure. 3 ) Run cords between the hooks and the fittings. 4 ) Tighten the cords until the panel is anchored but not pulled off balance. 1. Hook 2. Cord Fitting 12 mm to 18 mm (0.5 inches to 0.7 inches) M8 To stabilize the flat panel TV on a table or platform, use the supplied metal fittings and screws as well as commercially available wood screws. The wood screws are to anchor the metal fittings when mounting on a wooden surface. These screws should have a nominal diameter of 4 mm (5/32 inch) and are at least 20 mm (13/ 16 inch) long. Notes: Avoid moving the table after the panel is attached. Do not use bare wires for the cord. If any part of the wire is introduced into the ventilation port on the back of the display panel, fire or electrical shock could result. 24 En
![](/manual_guide/products/pioneer-pdp5020fd-owners-manual-2b634fd/24.png)