Pioneer PDP-503CMX Operating Instructions - Page 7
Installation - plasma
View all Pioneer PDP-503CMX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
INSTALLATION Attach the Main Unit NOTES: ÷ Always install the plasma display on a mobile cart before installing this unit. ÷ After installing this unit, never attempt to lift the plasma display to install on a mobile cart. ÷ If the need arises to move the unit after it is installed on a mobile cart, take care not to apply pressure on the unit when moving. Always lift by the mobile cart when moving. 3. Use the locking fixture on the rear panel to secure the four corners of the unit. 1 Rotate the locking fixture in the direction indicated by the arrow (rotate in the opposite direction for the left-side fixture), to secure the unit in place. 2 Press in the locking fixture's stopper to prevent the fixture from moving. Locking fixture 1 Release USB cable from cable clip. Cable clip USB Cable Stopper 2. Place the unit over the front of the plasma display. Attach the Pen Stand Use the furnished Allen bolt to fasten the pen stand in place to the rear side of the unit. Rear side of unit 20 En Pen stand Allen bolt ÷ Tighten the Allen bolt using an Allen wrench (width across flats of 6 mm).