Pioneer VSX-36TX Owner's Manual - Page 40

Initial Set Up Multi Channel In Setting If you have a Multi Channel external decoder you can choose whether to have the sound level set to BYPASS, that is coming out of the decoder at full volume, or set to ADJUST, which means the levels can be reduced in volume. If continuing from Dynamic Range Control go to step 1. If starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p.29) first. 1 Use the 5¥∞ buttons to select MULTI Î S0URCE MULTI OPERATION USE SETUP SYSTEM OFF RECEIVER DVD/LD TV/SAT VCR1 VCR2 MULTI CONTROL CD MD/ TAPE1 TUNER TVCONT CLASS MPX BAND DIRECT ACCESS ¶ 7 38 - + TUNING - + STATION 1¡ DTV ON/OFF DTV MENU 4¢ - + CHANNEL 123 CHANNEL IN. See "Setting Up for Surround Sound" on page 29 if you need more information. Press the ENTER button. This information will be displayed on your TV. 456 789 Multi channel in Select mode [Channel Level] GUIDE +10 + TV VOL - 0 TV TV CONTROL TV FUNC EXIT ENTER DISC + VOLUME - [EXIT] [BYPASS] REMOTE SETUP INPUT ATT SYSTEM SETUP EFFECT/ CH SEL MENU + MUTE FUNCTION DIGITAL NR ENTER - SIGNAL SELECT MIDNIGHT LIGHT MULTI CH INPUT THX DSP /DTS ADVANCED STEREO/ DIRECT STANDARD AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT 2 Use the 2¥3 buttons to select the setting 1-3 you want, BYPASS or ADJUST. ADJUST Use the ADJUST setting when you want to be able to control each channel level individually. BYPASS This setting is good for getting the cleanest possible signal. In this setting you won't be able to change each channel individually. We recommend using BYPASS and the default setting is BYPASS. 3 Use the 5¥∞ buttons to select EXIT. Press the ENTER button. You wil return to the SYSTEM SETUP mode. Multi Channel In Setting Using the Main Unit You can also use the main unit to change the sound level of the MULTI CH IN. Follow the step below. STANDBY/ON MULTI CH INPUT AUDIO/VIDEO MULTI-CHANNEL RECEIVER N∫m¿≤≥ım STANDBY/ON STANDBY DSP MODE STEREO/ DIRECT /DTS THX CINEMA ADVANCED STANDARD MULTI-ROOM &SOURCE CONTROL VIDEO VCR 1/DVR VCR 2 DVD/LD TV/SAT MD/TAPE1/ CD CD-R TUNER PHONO PHONES S-VIDEO VIDEO INPUT VIDEO L AUDIO R MULTI CH INPUT CHANNEL TONE SELECT DIGITAL SIGNAL FL LOUDNESS NR SELECT DIMMER CLASS BAND - TUNING + SPEAKERS - BASS + - TREBLE + VIDEO TAPE 2 SELCT MONITOR MPX TUNER CONTROL MEMORY - STATION + MIN INPUT SELECTOR MASTER VOLUME MAX 40 1 Put receiver in the STANDBY mode. 2 While holding down the MULTI CH INPUT button press the STANDBY/ON button. The setting will change depending on what state the receiver was previously in. For a few seconds the display will show you which MULTI CH setting you are now in. memo The default setting is BYPASS.