Pioneer VSX-36TX Owner's Manual - Page 60
Learning Commands from Other Remote Controls
View all Pioneer VSX-36TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Remote Control of Other Components Learning Commands from Other Remote Controls If preset codes are not available for your component(s), or the available preset codes do not operate correctly, you can use this function to program in signals from the remote control(s) of your other component(s). This operation can also be used after recalling a preset code to program additional operations not covered in the preset codes. 3 2,3 60 Î S0URCE MULTI OPERATION USE SETUP SYSTEM OFF RECEIVER DVD/LD TV/SAT VCR1 VCR2 MULTI CONTROL CD MD/ TAPE1 TUNER TVCONT CLASS MPX BAND DIRECT ACCESS ¶ 7 38 - + TUNING - + STATION 1¡ DTV ON/OFF DTV MENU 4¢ - + CHANNEL 123 456 7 GUIDE +10 + TV VOL - 8 0 TV TV CONTROL TV FUNC 9 EXIT ENTER DISC + VOLUME - REMOTE SETUP INPUT ATT SYSTEM SETUP EFFECT/ CH SEL MENU + MUTE FUNCTION DIGITAL NR ENTER - SIGNAL SELECT MIDNIGHT LIGHT MULTI CH INPUT THX DSP /DTS ADVANCED STEREO/ DIRECT STANDARD AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT 1 1 Set the remote control slide switch to SETUP. 4 Also make sure that your TV is on and set to the receiver. 2 Press the REMOTE SETUP button. The REMOTE SET UP menu appears on your TV screen. Select Remote Setup Mode Remote SETUP+1 Preset Recall Remote SETUP+2 Learning Remote SETUP+3 Multi-Operation Remote SETUP+4 Direct Function 3 Press the REMOTE SETUP button and 2 at the same time to select the learning setup mode. All the MULTI CONTROL buttons (except the TUNER button) start to blink. To cancel learning setup mode, press the REMOTE SET UP button. Learning Setup 1Place both commanders pointing at each other. 2Select the item from the Multi-control buttons that should be duplicated. (ex. DVD) Multi-control button starts blinking. EXIT = Remote Setup 4 Press the MULTI CONTROL button for the component you want to control. Each button can be set to control one of the following components. The selected button continues to blink. Learning Setup 3Press one button that should be duplicated. 4Multi-Contorol button lights up. 5Press one button on the original commander, and hold 2 to 10 seconds. 6Repeat this process to duplicate next command. EXIT = Remote Setup