Pioneer VSX-C300 Operating Instructions - Page 39
Resetting the System, Analog Input Mode, Checking your Settings
View all Pioneer VSX-C300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
English Using Other Functions Checking your Settings Use this feature to check your settings on the receiver's display. The meaning of the displays for the input signal are explained below. RECEIVER DVD INPUT SELECT REMOTE MASTER TV/SAT VCR SETUP VOLUME TUNER FRONT DISPLAY MUTING RECEIVER TV TV CONTROL TV INPUT SELECT CHANNEL VOLUME 1 1 Press the DISPLAY button on the remote control. Each press cycles through the five displays you can check for information with this function. These are: 1 The listening mode (see page 30) 2 The tone mode (see page 32) 3 The Midnight listening mode (see page 32) 4 The input signal (see below) 5 Returns to the normal display Analog Input Mode With this feature you can set the receiver to analog input mode. AUDIO/VIDEO MULTI-CHANNEL RECEIVER VSX-C300 VIRTUAL DTS MPEG PHONES SURR. STEREO DVD TV/SAT VCR TUNER FRONT DOWN MASTER VOLUME UP 1 1 1 While pressing the DVD button press the FRONT button. Hold for about one second. This sets all inputs (DVD, TV/SAT, etc.) to analog. You will see the following display. dB 2 Select the input you want to use for your analog input. MEMO: • When you change to another input the mode will be cancelled. • The mode is cancelled by turning the receiver off or doing step 1 again. MEMO: • If you don't press any buttons the receiver returns to the normal mode after five seconds. • The listening mode P. SURR refers to Headphones Surround mode. Resetting the System Use this feature to reset the system to its factory default settings. AUDIO/VIDEO MULTI-CHANNEL RECEIVER VSX-C300 VIRTUAL The Input Signal Displays Explained DTS MPEG PHONES SURR. STEREO DVD TV/SAT VCR TUNER FRONT MASTER VOLUME **k : sampling rate (PCM) **ch : number of channels DUAL : Dual Mono signal D.SRD : Dolby Surround signal DOWN UP 11 dB D.D. : Dolby Digital signal DTS : DTS signal MPG : MPEG signal PCM : PCM signal ANALOG : analog signal 1 Press the TV/SAT button and the FRONT button at the same time for five seconds to return all of the settings to their default mode. MEMO: • If the receiver is disconnected from a power source for more than a month, or the main power is turned off, it will reset to the default settings. • The above reset doesn't affect the presets that you have programmed into the remote control (see page 42). 39 En Downloaded from www.Manualslib.com manuals search engine