Pioneer VSX-D814-K Installation Manual - Page 12

02 5 minute guide Using the Quick Setup You can use the Quick Setup to get your system up and running with just a few button presses. The receiver automatically makes the necessary settings after you have selected your speaker setup, room size and listening position. If you want to make more specific settings, refer to Choosing your receiver setup on page 42. Use the front panel controls for the steps below. VSX-D914 model only - Note that you don't have to make these settings if you use the automatic MCACC setup instead (in this case, go straight to the Quick surround sound setup on page 14). SPEAKERS SB CH MODE MULTI JOG TONE QUICK SETUP VIDEO INPUT S-VIDEO VIDEO L AUDIO R ENTER MULTI JOG MASTER VOLUME DOWN UP 3 Use the MULTI JOG dial to choose your speaker setup. When a subwoofer was detected in step 2, you can cycle between the following choices: 2.1ch 3.1ch 7.1ch 6.1ch 5.1ch 4.1ch If a subwoofer wasn't detected in step 2, you can cycle between the following choices: 2.0ch 7.0ch 6.0ch 3.0ch 5.0ch 4.0ch • Check the table below to find the speaker setup that corresponds with your system. 1 If the receiver is off, press STANDBY/ON to turn the power on. 2 Press QUICK SETUP. SW DET flashes in the display while the receiver checks your setup for a subwoofer. SW YES or SW NO confirms the subwoofer check, then the display prompts you to select your speaker setup. 4 Press ENTER. 5 Use the MULTI JOG dial to choose your room size. Depending on the distance of your speakers from the listening position, choose between small, medium, or large (S, M or L), M being an average-sized room. 12 En