Pioneer VSX-LX805 ELITE 11.4 Channel AV Receiver Instruction Manual English - Page 183
Using Dirac Live
View all Pioneer VSX-LX805 ELITE 11.4 Channel AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
between 50 and 100 cm (20" and 40") away to the left and right of the listening position. "Full Measurement": Set up the microphone at ear height in the listening position for measurement. Next, measure in 8 positions to the front, back, left, right, etc., centered on the listening position. Measure by setting up the microphone in each of these positions, between 50 and 100 cm (20" and 40") away from the listening position. "Quick Measurement" "Full Measurement" Setup The illustration shows an image. 6. The guidance about outputting the test tone is displayed. Refer to the illustration to set up the speaker setup microphone in the listening position. Follow the on-screen instructions to measure. • Measurement may not be possible if the test tone is to loud or too soft. Tap "Level Adjust" to adjust the volume of the test tone. 7. When measurement is complete, "Calculating results" is displayed on the screen. Tap "Transfer to your product" to transfer the measurement data to the unit. 8. Disconnect the speaker setup microphone. • When measurement is performed with Dirac Live, selection in "MCACC Pro" - "Manual MCACC" ( →p160) and "MCACC Data Check" ( →p165) of the Home screen is no longer available. Furthermore, the measurement results are also reflected in "System Setup" - "Speaker" - "Distance" ( →p139) of the Home screen, and you will no longer be able to change the values. (The setting units are displayed as "msec".) Using Dirac Live You can apply the filter curves adjusted based on the measurement results of Dirac Live. From "Room EQ" - "Dirac Live" ( →p93) in "AV Adjust", select from "Slot1" to "Slot3". Note that the same data is saved in all of the slots, but you are able to create your own original sound quality in the following "Manual Adjust" section. • In the Home screen, when the number of speaker channels, etc., is changed in "System Setup" - "Speaker" - "Configuration" ( →p134), the measurement results are deleted. • When using Dirac Live, signals with a sampling frequency of 32 kHz are not supported. 183