Pioneer XW-NAC3-K Operating Instructions - Page 7

Before you start 01 English Français Español Before using the remote control The battery supplied with this unit is stored in the battery casing. • Remove the protective seal from the battery casing. When you notice a decrease in the operating range, replace the battery (see below). Replace the battery When replacing the battery, use a commercially available Lithium CR2025 battery. 1 1 3 2 1 While pushing the release tab, pull out the battery casing. 2 Remove the battery from the casing. 3 Place a new battery in the casing. Make sure the  side of the battery is facing up when you place it in the space provided. Caution When using lithium batteries, please observe the following: • There is danger of explosion if the battery is incorrectly replaced. Make sure to replace only with the same or equivalent type recommended by the manufacturer. • Dispose of used battery cells immediately after replacement. Keep away from children. • Store lithium batteries, out of the reach of children and infants. If accidentally swallowed, please contact a doctor immediately. • Lithium batteries may present a fire or chemical burn hazard if misused. Do not disassemble, heat above 100 °C, or incinerate. • Remove the battery if the unit isn't going to be used for a month or more. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. • WARNING Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. "Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/ perchlorate. (Applicable to California, U.S.A.) " 7 En