ProForm C840 Bench English Manual - Page 13

25. Insert an M10 x 19mm Hex Head Bolt (132) into 25 the bracket on the Weight Carriage (71) from the side shown. Orient the Weight Carriage (71) as shown and slide it onto the Rear Upright (38). Attach the Weight Carriage Stop (70) to the Rear Upright (38), at the indicated hole, with an M10 x 88mm Bolt (114) and an M10 Nylon Locknut (97). Make sure the Square Carriage Bushing (61) is on the bottom. 26. Press a 60mm Square Inner Cap (65) into the Rear Top Frame (39). 26 Attach the Rear Top Frame (39) to the Rear Upright (38) with two M10 x 72mm Hex Head Bolts (130), two M10 Washers (99), and two M10 Nylon Locknuts (97). Make sure the bolt heads are set inside the hex holes in the Rear Upright. Do not tighten the Locknuts yet. 65 97 70 114 61 132 71 Hole 38 39 97 99 99 130 38 27. Attach the Rear Top Frame (39) to the Center Upright (37) with two M10 x 78mm Bolts (110), two M10 Washers (99), and two M10 Nylon Locknuts (97). Do not tighten the Locknuts yet. Attach the Rear Top Frame (39) to the Top Frame (40) with two M10 x 127mm Bolts (126), four M10 Washers (99), and two M10 Nylon Locknuts (97). Do not tighten the Locknuts yet. 27 110 126 40 99 99 39 97 99 97 37 99 97 13