ProForm C840 Bench English Manual - Page 17
and an M10 Nylon Locknut 97.
View all ProForm C840 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
40. Locate the Low Cable (82). Route the eyelet end of the Cable through the Center Upright (37) and under a 90mm Pulley (90). Attach the Pulley inside the Upright with an M10 x 75mm Bolt (127), two M10 Washers (99), two 17mm Spacers (86), and an M10 Nylon Locknut (97). 40 37 97 99 86 90 82 86 99 127 41. Route the Low Cable (82) over a 90mm Pulley 41 (90) as shown. Attach the Pulley to the Double "U"-bracket (73) with an M10 x 45mm Bolt (112) and an M10 Nylon Locknut (97). 42. Route the Low Cable (82) under a 90mm Pulley 42 (90) as shown. Attach the Pulley to the Rear Base (33) with an M10 x 45mm Bolt (112) and an M10 Nylon Locknut (97). 97 112 97 90 82 90 82 97 33 43. Route the Low Cable (82) over a 90mm Pulley 43 (90) as shown. Attach the Pulley and a Cable Trap (125) to the second set of holes from the bottom of the two Pulley Plates (72) with an M10 x 45mm Bolt (112) and an M10 Nylon Locknut (97). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 112 97 90 72 112 125 82 17