ProForm C840 Bench English Manual - Page 8

9. Slide the Thick Pad Tube (10) into the hole in the Leg Lever Bracket (5). Wet both sides of the Pad Tube with soapy water. Slide two Small Foam Pads (18) onto the Tube as shown. Press two 19mm Square Inner Caps (19) into the Pad Tube. Slide a Pad Tube (9) into a hole in the Leg Lever (4). Wet both sides of the Pad Tube with soapy water. Slide two Large Foam Pads (17) onto the Pad Tube as shown. Press two 19mm Square Inner Caps (19) into the Pad Tube. Repeat with the other Pad Tube. 9 19 19 18 5 17 4 9 9 10. Attach the Curl Pad (16) to the Curl Post (6) with 10 two M6 x 16mm Screws (104). 16 10 18 17 19 19 11. Press a Round Angled Bushing (75) into a Rack 11 Foot (46). Attach a Guide Bar (41) to the Rack Foot (46) with an M10 x 50mm Screw (108) and an M10 Washer (99). Attach the Right Upright (69), which has numbers on the indicated side, to the Rack Foot (46) with two M10 x 68mm Bolts (113), four M10 Washers (99), and two M10 Nylon Locknuts (97). Make sure the Bolts are inserted from the side shown. Do not tighten the Locknuts yet. Repeat this step with the Left Upright (36 [not shown]), Guide Bar (41), Rack Foot (46), and Round Angled Bushing (75). Insert the M10 x 68mm Bolts (113) from the other side. 8 6 104 41 69 Numbers 99 97 99 99 75 113 99 46 99 108