Sanyo PDG-DXL2000 Owners Manual - Page 14
Remote Control Battery Installation, Remote Control Operating Range, Remote Control Code, Code 1
UPC - 086483079436
View all Sanyo PDG-DXL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Part Names and Functions 1 Open the battery compartment lid. Remote Control Battery Installation 2 Install new batteries into the compartment. 3 Replace the compartment lid. Two AAA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in compartment. To ensure safe operation, please observe the following precautions : l Use two (2) AAA or LR03 type alkaline batteries. l Always replace batteries in sets. l Do not use a new battery with a used battery. l Avoid contact with water or liquid. l Do not expose the remote control to moisture or heat. l Do not drop the remote control. l If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries. l Risk of an explosion if battery is replaced by an incorrect type. l Dispose of used batteries according to the instructions or your local disposal rule or guidelines. Remote Control Operating Range Point the remote control toward the projector (Infrared Remote Receiver) when pressing the buttons. See the below figures indicating Maximum operating range for the remote control. 11.5' (3.5 m) 16.4' (5 m) 16.4' (5 m) Remote Control Code The two different remote control codes (Code 1-Code 2) are assigned to this projector. Switching the remote control codes prevents interference from other remote controls when several projectors or video equipment next to each other are operated at the same time. Change the remote control code for the projector first before changing that for the remote control. See "Remote control" in the Setting Menu on page 58. Press and hold the MENU and IMAGE buttons for more than five seconds to switch between the Code 1 and Code 2. The initial code is set to Code 1. MENU button IMAGE button 14