Sanyo PDG-DXL2000 Owners Manual - Page 52

Setting 3D setting This function is used to set the 3D display function. (pp.4849) Press the Point ed buttons to switch between each option. 3D Select among Off, On and NVIDIA 3D VISION mode. * When selecting NVIDIA 3D VISION mode, the other menus 3D sync, 3D->2D, 3D phase setting are not necessary. (displayed in gray) 3D sync....If you see a discrete or overlapping image, 3D Sync Invert function* enables you to get the correct image. Switch the 3D sync signal to 1 or 2. 3D->2D......When viewing the 3D contents without wearing the 3D glasses, set to "On" to convert 3D display format to 2D display format. 3D phase...Adjust the phase of the 3D sync signal when the 3D SYNC OUT terminal is used. (0 - 31) * The Frame Sequential Format is a technology that rapidly alternates between left-eye and right-eye images. When right-eye image and left-eye image are switched or you feel like you cannot get 3D effect due to out-ofsynchronization state, first try to synchronize the projector with the 3D glasses by using 3D SYNC function. 3D setting Zoom This function is used to memorize the Zoom adjustment with the ZOOM +/- buttons on the top control (p.25). Press the Point ed buttons to select Reset, Store1 or Store2. Reset . . . Reset the Zoom adjustment when the projector is turned off or the AC power cord is unplugged. Store1 . . Store the Zoom setting even when the projector is turned off. Zoom setting is cleared when the AC power cord is unplugged. Store2 . . Store the Zoom setting even when the AC power cord is unplugged. 52