Sanyo PLV Z3 Owners Manual - Page 53

Appendix Indicators and Projector Condition Check the indicators for projector condition. Indicators POWER LAMP red/green/ WARNING REPLACE orange red yellow Projector Condition The Main On/Off switch is off or the AC power cord is unplugged. ✽ The projector is preparing for stand-by. Or the projection lamp is being cooled down. The projector cannot be turned on until cooling is completed. ✽ The projector is ready to be turned on with the POWER ON-OFF button. ✽ The projector is operating normally. ✽ The projector is in the Power management mode. The temperature inside the projector is abnormally high. The projector can- not be turned on. When the projector is cooled down enough and the ✽ temperature returns to normal, the POWER indicator lights red and the pro- jector can be turned on. (The WARNING . indicator keeps flashing.) Check and clean the Air filter. The projector has been cooled down enough and the temperature returns ✽ to normal. When turning on the projector, the WARNING indicator stops flashing. Check and clean the air filter. The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn on the projector. If the ✽ projector is turned off again, disconnect the AC power cord and contact the dealer or the service center for service and checkup. Do not leave the pro- jector on. It may cause electric shock or a fire hazard. The lamp does not light because malfunction occurs or the lamp life comes to an end. ✽ The front cover is closed. • • • lights green. • • • flashes green. • • • lights orange. • • • lights red. • • • flashes red. • • • flashes yellow. • • • off ✽ When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the Lamp replace counter after replacement of the lamp. See page 50 and 51. 53