Sanyo XU86 Instruction Manual, PLC-XU86 - Page 15

Remote Control Battery Insta..., Operating Range, Adjustable Feet

Page 15 highlights

Part Names and Functions Part Names and Functions Remote Control Battery Installation 1 Open the battery compartment lid. 2 Slide the batteries into the compartment. 3 Replace the compartment lid. Press the lid downward and slide it. Two AAA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in compartment. To insure safe operation, please observe the following precautions : ● Use (2) AAA,UM-04 or LR03 type alkaline batteries. ● Always replace batteries in sets. ● Do not use a new battery with a used battery. ● Avoid contact with water or liquid. ● Do not expose the remote control to moisture, or heat. ● Do not drop the remote control. ● If the battery has leaked on the remote control, carefully wipe case clean and install new batteries. ● Risk of an explosion if battery is replaced by an incorrect type. ● Dispose of used batteries according to the instructions. Operating Range Point the remote control toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum operating range for the remote control is about 16.4' (5m) and 60° in front of the projector. 16.4' (5 m) 60° Remote control Adjustable Feet Projection angle can be adjusted up to 10.0 degrees with the adjustable feet. 1 Lift the front of the projector and pull upward the feet lock latches on both sides of the projector. 2 Release the feet lock latches to lock the adjustable feet and rotate the adjustable feet to adjust the position and tilt. 3 Keystone distortion of the projected image can be adjusted automatically with Auto setup function or manually with the remote control or the menu operation. (p25, 46, 47) Adjustable Feet Feet Lock Latches 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

15
Projection angle can be adjusted up to 10.0 degrees with
the adjustable feet.
Lift the front of the projector and pull upward the feet
lock latches on both sides of the projector.
1
Adjustable Feet
Feet Lock Latches
Release the feet lock latches to lock the adjustable
feet and rotate the adjustable feet to adjust the
position and tilt.
2
Keystone distortion of the projected image can be
adjusted automatically with Auto setup function or
manually with the remote control or the menu
operation.
(p25, 46, 47)
3
Adjustable Feet
Part Names and Functions
T
o insure safe operation, please observe the following precautions :
Use (2) AAA,UM-04 or LR03 type alkaline batteries.
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture, or heat.
Do not drop the remote control.
If the battery has leaked on the remote control, carefully wipe case clean and install new batteries.
Risk of an explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Press the lid
downward and slide it.
Open the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the
compartment lid.
Two AAA size
batteries
For correct polarity (+
and –), be sure
battery terminals are
in contact with pins
in compartment.
1
2
3
Point the remote control toward the projector (Infrared
Remote Receiver) whenever pressing any button.
Maximum operating range for the remote control is about
16.4’ (5m) and 60° in front of the projector.
16.4’
(5 m)
60°
Remote control
Part Names and Functions
Operating Range
Remote Control Battery Installation