Sanyo XU86 Instruction Manual, PLC-XU86 - Page 29

Computer Input Input Source Selection (RGB : Computer 1(Analog) / Computer 2 ) Direct Operation Choose either Computer 1(Analog) or Computer 2 by pressing the INPUT button on the top control or press the COMPUTER button on the remote control. Before using these buttons, correct input source should be selected through Menu operation as described below. Top Control POWER WARNING LA ON - OFF MENU INPUT AUT SELECT INPUT button INPUT button Computer 1 (Analog/Digital) Computer 2 ✳ Video Remote Control Wired COMPUTER button COMPUTER button Computer 1 (Analog/Digital) Menu Operation 1 Press the MENU button to display the On-Screen Menu. Press the Point 7 8 buttons to move the red framed pointer to the Input Menu icon. 2 Press the Point ed buttons to move the red arrow pointer to either Computer 1(Analog) or Computer 2, and then press the SELECT button. Computer 2 ✳ ✳ See Note at the bottom of this page. Input Menu Input Menu icon Move the pointer (red arrow) to Computer 1 (Analog) and press the SELECT button. Computer Input 3 When selecting Computer 1(Analog), RGB input source will be selected directly. When selecting Computer 2, the Source Select Menu will appear. Move the pointer to RGB and then press the SELECT button. ✔Note: •Computer 2 is not displayed when the COMPUTER IN 2 / COMPONENT IN / MONITOR OUT terminal is set as Monitor out. (p50) •Computer 2 (COMPUTER IN 2 / COMPONENT IN /MONITOR OUT) can accept only RGB signal. •Wired, Wireless, Memory Viewer are for the Network function. See owner's manual (Additional Vol.) and owner's manual of Memory viewer (optionally available). Input Menu Computer 2 Input Menu icon Move the pointer (red arrow) to Computer 2 and press the SELECT button. Move the pointer (red arrow) to RGB. 29