Sanyo XU86 Instruction Manual, PLC-XU86 Network Set Up - Page 83

10. How to Use the PJ Controller English Image Adjustment On this screen, you can adjust the image projected from the projector. Select an Image Adjustment Mode from the pulldown menu and click Set button. The items displayed on this screen is automatically changed according to the input signal. Click 7 8 buttons to adjust the value. Every time you change the value, click Set button. if you click Reset button, all the adjusted values will be reset. ✳ Some items may not be adjusted depending on the functions of your projector or input signal. In this case, " ----" will be shown in the field of the item. Parameter Description Image Adjustment Mode....Select from "Dynamic", "Standard", "Real*", "Cinema**", "Black Board", "Image 1 - 4", from the pull-down list. Image 1 - 4 can be set by users. Original Mode Displays the original mode. Contrast Click 7 8 to adjust the image contrast. Brightness Click 7 8 to adjust the image brightness. Tint Click 7 8 to obtain a proper image.*** Color Click 7 8 to adjust the color intensity. White Balance Color Temp Click 7 8 to adjust the color temp level. (XLow, Low, Mid or High) Red, Green, Blue Click 7 8 to adjust white balance of the image. Gamma Click 7 8 to obtain a better balance of contrast. Sharpness Click 7 8 to adjust the image sharpness. Noise Reduction Set the Noise Reduction function. Progressive Switch progressive mode : "Off", "L1"(motion picture), "L2"(still picture), Film Comment You can save a note regarding Image Adjustment. Click "Save" to save the note. Store You can save the settings of the Image Adjustment. Select the mode number you wish to save and click Set button. If you click "Reset", all the adjusted values will be reset. * Items only for computer input. ** Items only for video input. *** If the color system is PAL, SECAM, PAL-M or PAL-N, tint cannot be adjusted. 83