Sennheiser ew 100 Instructions for Use - Page 68

Selecting the frequency, channel number Ǡ With the ̆/̄ buttons you can directly switch between the factorypreset frequencies (channel presets). The display starts flashing. Your selection becomes effective immediately. Ǡ Press the SET button to acknowledge your selection. The display stops flashing. (If the SET button is not pressed, the receiver will store the new frequency automatically on switch-off.) Note: You can choose the content of the standard display i.e. whether the frequency or the channel number is displayed (u "Selecting the content of the standard display"). The receiver is factory-preset to show the frequency setting as standard. SenSit Adjusting the sensitvity (transmitters only) Close talking distances, speakers with loud voices or loud music sequences may cause overmodulation in the transmission link, resulting in distortion. In this case, the "PEAK" warning of the EM 100's AF level display (as well as the SK 100 transmitter's yellow audio peak indication LED) will light up. If, on the other hand, the sensitivity is adjusted too low, the transmission link will be undermodulated, which would result in a signal with high background noise. The sensitivity has to be adjusted such that the "PEAK" warning of the receiver's AF level display only lights up during the loudest passages. The following figures are a guide to the best settings: Loud music/vocals: Presentations: Interviews: -30 / -20 dB -20 / -10 dB -10 / 0 dB Ǡ Select the "SEnSit" menu by pressing the SET button until "SEnSit" appears on the display; after a short pause the current sensitivity setting is displayed. Ǡ With the ̆/̄ buttons you can now select a different setting. The sensitivity can be adjusted in 10-dB steps from 0 to -30 dB. The new setting starts flashing on the display and becomes effective immediately. Ǡ Press the SET button to return to the top menu level. The display then switches back to the standard display. 70