Sharp DT 500 DT-500 Operation Manual - Page 36
H & V Keystone
UPC - 074000364837
View all Sharp DT 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
H & V KEYSTONE 1 Project the image and adjust the focus, image size, and projection angle. 2 Press c KEYSTONE on the remote control repeatedly until "H & V KEYSTONE" is displayed. • When the "GEOMETRIC ADJUSTMENT" mode has been used to adjust the image, a confirmation screen displays before the "H & V KEYSTONE" screen, asking if you want to reset the adjustments or not. Then select RESET. R On-screen display H&V KEYSTONE END ENTER ADJUST RESET 3 Press P or R on the remote control to align the left and right sides of the projected image. Vertical Keystone Correction (Adjustment with P / R) 4 Press O or Q on the remote control to align the upper and lower sides of the projected image. Horizontal Keystone Correction (Adjustment with O / Q) Basic Operation 5 Press c KEYSTONE or i ENTER on the remote control and the "H&V KEYSTONE" mode ends. Note • If adjustments are made using both "H KEY- STONE" and "V KEYSTONE" at the same time, the image aspect ratio may become slightly distorted. • When adjusting "H KEYSTONE" and "V KEYSTONE" at the same time, the values of adjustable angles for each setting become smaller. • The adjustable value of the "V KEYSTONE" becomes extremely small when "H KEYSTONE" is made to be the maximum value. 35