Sharp PN-C703B Pen Software Operation Manual - Page 23

Touch action Rotation Use this action in a screen that is capable of image rotation. Touch the center point of the rotation with one finger. While holding that finger still, move another finger in the desired direction of rotation. Move another finger in the desired direction of rotation With one finger touching Eraser Only use an eraser that is supplied with this monitor. The eraser is used with the Pen Software. For the procedure for using the eraser, refer to the Pen Software Operation Manual. Caution • Hold the main body of the eraser with your bare fingers. The screen will not respond if you are wearing a glove. The main body TIPS • The screen may not respond correctly in the following cases: Touch gesture is too quick The distance between the two points is too short The two points intersect • Slowly place the large face of the eraser fully on the screen. Insufficient contact may prevent the eraser from being recognized. Touching the screen with one of the noncloth sides will damage the screen. Other functions In Windows 8.1/10, input panel functions can be used. In Windows 7, touch pointer and input panel functions can be used. For information on these functions, see Windows Help. Touch pointer : A translucent image of a mouse appears near the point touched. The left/right buttons of the image can be clicked to perform the same actions as left/right clicking a mouse. Input panel : A software keyboard and an input panel with handwriting recognition appear on the screen. Windows 8.1/10 and Windows 7 (excluding Starter), the ink function of Microsoft Office can be used. Handwritten comments can be written, and handwriting can be recognized. For details, see Microsoft Office Help. Cautionary points • Note the following when touching by finger: - Do not touch with a wet finger. - Touch with the ball of your finger. - Touch with your bare finger. The screen will not respond if you are wearing a glove. • Do not use the touch pen for any purpose other than touch panel operation. • Do not press hard on the pen tip. • This may not operate correctly if there is an inverter fluorescent light nearby. • Do not store with the pen tip of the touch pen or function button pressed. The battery will be exhausted. • If there is dirt or foreign matter on the tip of the touch pen, remove it. Foreign matter may damage the screen. • The touch pen position may occasionally deviate in the login screen. In this case, use the keyboard or mouse. • If the USB cable becomes disconnected, the touch panel may not operate correctly after the USB cable is reconnected. In this case, restart the computer. • If there is any dirt or foreign matter on the surface that contacts the screen, remove it. Foreign matter may damage the screen. • Place the eraser on the screen inside the display area. If the eraser first touches the frame (outside the display area) and then is moved inside the display area, the screen will not respond. • When the "Touch Operation Mode Setting" of the Touch pen Management Tool is "Pen digitizer Mode": - Even if you use the eraser in the Pen Software, the eraser will be the standard size eraser. - The eraser can be used in the software below. Microsoft Office 2007/2010/2013/2016 23 E