Sharp PN-C703B Pen Software Operation Manual - Page 40
Controlling the Monitor with a PC (RS-232C), PC connection, Communication conditions, Communication
![]() |
View all Sharp PN-C703B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Controlling the Monitor with a PC (RS-232C) You can control this monitor from a PC via RS-232C (COM port) on the PC. TIPS • To control the monitor via RS-232C, set RS-232C/LAN SELECT to RS-232C. • When STANDBY MODE is set to LOW POWER, control is not possible in standby mode. • You cannot use RS-232C and LAN control simultaneously. PC connection Connect the RS-232C conversion cable (supplied) to the RS232C input terminal on the monitor. Connect the RS-232C conversion cable (supplied) to the COM port (RS-232C port) on your computer with an RS-232 cable (straight). Communication conditions Set the RS-232C communication settings on the PC to match the monitor's communication settings as follows: Baud rate Data length Parity bit * 8 bits None Stop bit 1 bit Flow control None * Set to the same baud rate as the BAUD RATE setting of SETUP menu. (Initial setting: 38400 bps) Communication procedure nCommand format When a command is sent from the PC to the monitor, the monitor operates according to the received command and sends a response message to the PC. Return code RS-232C input terminal Computer To COM port RS-232 straight cable RS-232C conversion (commercially available) cable (supplied) C1 C2 C3 C4 P1 P2 P3 P4 Command field Parameter field (4 prescribed (4 character string comprised of: alphanumerical characters) 0-9, +, -, space, ?) Example: VOLM0030 VOLM 30 * Be sure to input 4 characters for the parameter. Pad with spaces (" ") if necessary. (" " is a return code (0DH, 0AH or 0DH)) Wrong : VOLM30 Right : VOLM 30 When inputting a negative value, specify a numerical value in three digits. Example: AUTR-005 Do not use spaces for MPOS, DATE, and SC01 through SC08. Specify parameters using a specified number of characters. Example: MPOS010097 If a command has "R" listed for "Direction" in the "RS-232C command table" on page 43, the current value can be returned by using "?" as the parameter. Example: VOLM ? ? ? ? 30 ← From PC to monitor (How much is current volume setting?). ← From monitor to PC (Current volume setting: 30). E 40
![](/manual_guide/products/sharp-pnc703b-pen-software-operation-manual-46a9497/40.png)