Sharp VL-NZ100U VLNZ100U|VLNZ150U Operation Manual - Page 40
Watching Playback on
View all Sharp VL-NZ100U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Basic Operations Basic Operations Playback Watching Playback on a TV Available modes: TAPE-VCR, CARD-VCR You can connect the camcorder to a TV to allow a larger audience to enjoy playback. 1 Open the jack cover on the camcorder (see page 2). Jack cover 2 Connect the camcorder to your TV (or VCR) with the supplied audio/video cable, as shown. Caution: • Check that the camcorder, TV, VCR and other equipment to be used are turned off before making any connections. Picture noise or malfunction may occur if any of the above is left on while making a connection. 3 Turn on the TV and set it to the "AV" or "VIDEO" channel. (See the operation manual of your TV.) • When connecting to a TV via a VCR, turn on the VCR and set it to the "AV" or "LINE" input channel. Operate the TV as you normally do to view the signal from the VCR. (See the operation manuals of your TV and VCR.) 4 Set the Power switch on the camcorder to VCR, and begin playback (see page 23). Notes: • If your TV or VCR has only one audio input jack, use the white plug for the audio connection on the TV or VCR. • Close the jack cover after use. POWER TV/VCR SET UP PLAY PAUSE /STILL STOP/ EJECT CHANNEL REC Yellow: To video input jack White: To audio input (L) jack Red: To audio input (R) jack Audio/video cable (supplied) To AV jack : The arrow shows the signal flow. 25