Sharp VL-NZ100U VLNZ100U|VLNZ150U Operation Manual - Page 65
Using the Camcorder as, a Converter
View all Sharp VL-NZ100U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Using the Camcorder as a Converter Available mode: TAPE-VCR You can use this camcorder to convert from analog signal (e.g. video recorded on 8 mm or Hi8 tapes) to digital signal. Connect the audio/video cable and DV cable as shown below. To DV terminal Recording (digital equipment) e.g. computer 1 Set the camcorder to TAPE-VCR mode, and make sure that playback stops. 2 Press the MENU button to display the menu screen. 3 Press l or m on the operation button to select V, then press the SET button. 4 Press l or m to select "ANLGnDGTL", then press the SET button. PLAYBACK SET P I C. EFF ECT AUD I O DUB AUD I O ANLG DGTL OF F RE T URN ON DV cable (commercially available) Digital signal To DV terminal To AV jack Analog signal Audio/video cable (supplied) Yellow: To video output jack White: To audio output (L) jack Red: To audio output (R) jack Playback (analog equipment) e.g. 8 mm or Hi8 camcorder : The arrow shows the signal flow. Note: • See page 2 for how to open the jack cover. 5 Press l or m to select "ON", then press the SET button. ANLG DGTL ON 6 Press the MENU button to turn off the menu screen. 7 Press the Play button on the analog equipment • Check the monitor on the digital equipment to see if the picture is being properly received. 8 Press the Record button on the digital equipment. Notes: • The camcorder is not guaranteed to work with all digital/analog equipment. Contact the manufacturer of your equipment for advice. • If the camcorder outputs a video recording with a copyright signal, the digital equipment cannot record or save it. • The camcorder may not convert some input video recordings properly (e.g. discoloration, picture noise, muted sound), depending on the input condition. Advanced Features 50