Sony EVIHD7V Product Manual (HD Color Video Camera) - Page 13

Basic Functions Initial Settings and Position Preset The initial values are those set at the factory. Settings for items in Position presets 1 to 6 that will be retained even when the power to the camera is turned off are indicated by a "Yes," those that will be lost are indicated by an "No." • When the power is turned on, the settings retained in POSITION 1 will be called up as the initial settings. • When a CAM_Memory Reset command is sent, or a choice is made from POSITION 1 to 6 while the RESET button on the Remote Commander is being pressed, the settings selected will be used as the initial settings. • Position preset 1 becomes VISCA command CAM_Memory memory number 0. Position presets 2 through 6 become VISCA command CAM_Memory memory numbers 1 through 5. Category Mode/Position Initial settings Pan/Tilt Pan/Tilt Position Pan/Tilt Limit Position Zoom Zoom Position D-Zoom Limit Focus Position Focus Focus Auto/Manual Near Limit Setting WB Mode WB WB Data (Rgain, Bgain) One Push WB Data AE Mode AE Gain Limit Shutter Position Iris Position AE Gain Position Bright Position Exposure Compensation On/Off Exposure Compensation Amount Backlight On/Off Apperture Aperture Level IR IR_Receive On/Off IR_ReceiveReturn On/Off OSD Display Information On/Off Video System Video Format Memroy Color System Preset Memory Home position movable-range maximum Wide end x4 - Auto 7600h Auto - - Full Auto 18 dB 1/60 sec (59.94/29.97), 1/50 sec (50/25) - - - Off ±0 Off 8 On Off On Rear panel SYSTEM SELECT: pos HD7V: 0 (1920×1080p/59.94) HD7V (CE): 8 (1920×1080p/50) HD3V: 3 (1280×720p/59.94) HD3V (CE): B (1280×720p/50) RGB Same as the initial value setting Position preset 1 Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes No Position presets 2 to 6 Yes No Yes Yes Yes Yes No Yes Yes No Yes No Yes Yes Yes Yes Yes Yes Yes Yes No No No No Yes No Yes Yes Notes • The number of times data can be written to the EEPROM (by executing Position Preset) is limited. • If you want the camera status and Pan/Tilt positions in effect before the camera is turned off to be retained when the power is turned OFF, then turned ON again, have the camera memorize those positions in POSITION 1. • It takes approximately 2 seconds longer to memorize or erase settings in POSITION 1 than it does to memorize or erase settings in any other channel. • Camera ID data will be saved regardless of the position preset. 13