Sony KDF-55E2000 Operating Instructions - Page 83
General, POWER, Parental Lock, Reset, Label Video Inputs, Advanced Iris, Cooling, Normal - 3 blinks
View all Sony KDF-55E2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Other Information General Problem Possible Remedies How to reset TV to factory settings ❏ Turn on the TV. While holding down the M button on the remote control, press the POWER button on the TV. Release the POWER button then release the M button. The TV will turn itself off, then back on again with Initial Setup. WARNING: This operation will clear all of your customized settings including Parental Lock setting. How to restore Picture settings ❏ Select Reset setting option while in the Picture setting (see page 59). to factory settings How to restore Sound settings ❏ Select Reset setting option while in the Sound setting (see page 62). to factory settings Cannot cycle through the other ❏ Be sure the Label Video Inputs option is not set to Skip (see page 71). video equipment connected to the TV Cannot operate the setting ❏ If a setting option appears in gray, this indicates that the setting option is not available. Lost password ❏ On the password screen (see page 68), enter the following master password: 4357. The master password clears your previous password; it cannot be used to temporarily unblock channels. TIMER LED on front panel is ❏ When lit, indicates that the timer is set (see page 72). When the timer is set, this lit LED will remain lit even when the TV is turned off. LAMP LED blinks in red ❏ Replace the lamp (see page 76). Digital cable box does not work ❏ If you are connecting a VCR and digital cable box using a splitter, as described on page 31, you must use a special bi-directional splitter that is designed to work with your digital cable box. Contact your cable provider for details. Cannot record digital channels ❏ Only analog channels can be recorded to your VCR. to VCR TV cabinet creaks ❏ When the TV is in use, there is a natural rise in temperature, causing the cabinet to expand or contract and may be accompanied by a slight creaking noise. This is not a malfunction. A slight creaking noise occurs ❏ Advanced Iris applies a mechanical iris system. When Advanced Iris is set, a from the bottom part of the TV natural creaking noise occurs due to the basic structure of the optical unit. The creaking sound is an inherent nature of this system and is not a defect. The cooling fan is loud ❏ If the TV is used at high altitudes and set to High, the cooling fan runs faster and its sound becomes louder. If the TV is not used at high altitudes, set Cooling Mode to Normal (see page 73). "High Temperature Warning!" ❏ Make sure to remove dust from the ventilation slots on the rear and both sides of message appears the TV. In addition, make sure that there are no obstacles in front of the ventilation slots. If the message still appears after the dust or obstacles are removed, the TV may need servicing. Call your local Sony Service Center. The TV does not turn on ❏ The TV cools down its projection lamp when the power is turned off. It takes up to two minutes for the picture to come back after the TV is turned on again. Wait for a while until the picture comes back. (Continued) 83