Sony KDL46VL160 Operating Instructions - Page 26
Programming the Remote Control, Programming Other Equipment, Auto Backlight, Backlight Time Out - no picture
View all Sony KDL46VL160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Programming the Remote Control The remote control can be programmed to operate other equipment and is pre-programmed to operate the following Sony equipment. Function Button Sony Equipment Code Number DVD DVD Player 31033 AMP Receiver 52172 STB Digital Satellite 01639 Programming Other Equipment ~ • Any of the FUNCTION buttons can be programmed to operate other equipment regardless of the labeling. For example, DVD can be programmed to operate a Bluray player. Confirm the Programming If you can turn your equipment on and off using the green POWER button, the programming is complete. If not, try the next code listed. ~ • In some cases, you may not be able to program your remote control. If this is the case, use your equipment's own remote control. DISPLAY LIGHT POWER TV POWER DVD AMP STB TV 2 FUNCTION PREV REPLAY ADVANCE NEXT PLAY SYNC MENU PAUSE STOP THEATER SOUND PICTURE WIDE CC FREEZE 2 4 Auto Backlight The backlight can be set to light up when a button is pressed. To set backlight: Press LIGHT and MUTING simultaneously until the four FUNCTION buttons blink red. To turn off backlight: Press LIGHT and MUTING until the TV button blinks red. 3 VOL CH Follow the steps below to program your TV remote control. 1 Find the code that corresponds to your equipment from page 27. If more than one code is provided, try programming the first code listed. 2 Press and hold DVD, AMP or STB simultaneously with the INPUT button and release. When in the programming mode, the FUNCTION button blinks for approximately 30 seconds until a code is entered. 3 Enter the five digit code using 0-9. while the FUNCTION button is lit. If the code is not entered within 30 seconds, you must repeat step 2. 4 Press or ENT to confirm the code. If successfully programmed, the FUNCTION button blinks twice; if not, it blinks five times. 26 Backlight Time Out The remote control can be set to remain lit longer than the default time setting of approximately five seconds with the FUNCTION buttons. To change backlight time setting: 1 Press LIGHT, VOL+, and then CH+ simultaneously until the FUNCTION button blinks red. 2 Select the FUNCTION button that corresponds to your preferred time out setting and press . DVD 5 seconds (default) STB 15 seconds AMP 10 seconds TV 20 seconds Reset the Remote Control To reset the remote control to the factory default settings, press and hold SOUND, TV POWER, and then simultaneously. The FUNCTION buttons blink red simultaneously when successfully reset.