Sony MDP-600 Primary User Manual - Page 43

3 Turn on the TV and stereo system 46, 4 Open the disc tray TV: Set to "Video-. Stereo system: Turn on the amplifier or receiver and select CD or AUX for audio output. Fay uno a ilsof owl &W m 5 Place a disc on the tray Carefully center a single disc on the tray. The disc will not play if it is not seated properly. CDICDV Always insert one disc at a time. Inserting more than one may damage the player. 7 Adjust the microphone volume EcHosusc MIC LEVEL control Adjust the microphone volume with the MIC LEVEL control (the inner knob). Sound from a microphone cannot be output when the player is connected to the amplifier with a Fiber Optical Cable. To output sound from a microphone, use an Audio Cable (Red & White plugs) for connection. If the output Is distorted The output may sound distorted when Nstening through your TV speakers. Correct this by setting the ATT (Attenuator) switch on the rear panel of the player to ON. (This will lower the volume which should now be adiusted with the volume control on the TV. 6 Choose a selection to play e®zr0th0ail • The disc tray doses automalically and • ; play starts. 410 • Press PLAY ( le) or push the disc tray to playback from the beginning of the disc (side A of the LD). • To choose a selection on side B of the LD, press DISC SIDE B, then press the number key(s). • If the picture on the TV flickers The picture appearing on the TV screen may flicker when listening through your TV speakers and the MIC volume is set too high. Correct this by setting the ATT (Attenuator) switch on the rear panel to ON, or lower the MIC LEVEL