Sony MZ-R91 Operating Instructions - Page 47
Sony MZ-R91 Manual
View all Sony MZ-R91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Messages If the following error messages flash in the display window, check the chart below. Error message BLANKDISC DISC ERR Meaning/Remedy • An MD with no recording on it is inserted. , Insert a recorded MD. • The disc is damaged or does not contain proper recording or editing data. , Reinsert the disc. If this fails, rerecord. • There is no more space to record on the disc (less than 12 seconds available). , Replace the disc. • The MD player is recording information (sounds) from the memory to the disk. , Wait until this process is completed. Do not expose the player to any physical shock, nor disrupt power supply. • The MD player is recording information (track start and end position) from the memory to the disk. , Wait until this process is completed. Do not expose the player to physical shock, nor disrupt power supply. • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take 2-3 minutes). • You tried to enter more than 200 letters to label a single track or disc. • You tried to enter a total of more than 1700 letters for track or disc names during playback or stop. , Enter the characters within the limit. • Voltage of the power supply is too high (The supplied AC power adaptor or the recommended car battery cord is not used). , Use the supplied AC power adaptor or the recommended car battery cord. • The recorder is locked. , Slide HOLD against the arrow to unlock the recorder (page 29). • Batteries are weak. , Charge the rechargeable battery or replace the dry battery (page 40). • You tried to record with the recorder placed where it receives continuous vibration. , Put the recorder on a stable place, and start recording again. DISC FULL Data Save TOC Edit BUSY NAME FULL Hi DC in HOLD LOW BATT MEM OVER 47