Sony PXW-Z190 Setup Guide for Wireless Network Connection - Page 28

Network Client Mode Settings

Get Sony PXW-Z190 PDF manuals and user guides View all Sony PXW-Z190 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

5.4. Network Client Mode Settings Check that the Date Time settings in System > Clock Set are correct before configuring the Network Client Mode settings. Network Client Mode presets can be configured in NCM Settings 1 to 3. The following procedure describes how to set NCM Settings1 as an example. 1 Select Network > Network Client Mode > NCM Settings1 in the setup menu. The registration dialog appears. 2 Enter the URL or IP address for Connection Control Manager (CCM), and specify the port, user name, and password. 3 Select the Set button on the menu screen, and press the SEL/SET dial or SET button. NCM Settings detail settings: [Camera Control]: Enables camera control from the CCM UI. [Camera Setting]: Enables "ALL File" operations from the CCM UI After loading an ALL file from the CCM, the camcorder will reboot. After rebooting: Always: Enables "ALL File" operations continuously. Onetime: Enables "ALL File" operation once only, then the setting changes to "Off". Presets can be selected based on your use case. For example, you can set [NCM Settings1] for XDCAM air and [NCM Settings2] for Network RX Station. 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
28
5.4. Network Client Mode Settings
Check that the Date Time settings in System > Clock Set are correct before configuring the Network Client
Mode settings.
Network Client Mode presets can be configured in NCM Settings 1 to 3.
The following procedure describes how to set NCM Settings1 as an example.
1
Select Network > Network Client Mode > NCM Settings1 in the setup menu.
The registration dialog appears.
2
Enter the URL or IP address for Connection Control Manager (CCM), and specify the port, user name,
and password.
3
Select the Set button on the menu screen, and press the SEL/SET dial or SET button.
NCM Settings detail settings:
[Camera Control]: Enables camera control from the CCM UI.
[Camera Setting]: Enables “ALL File” operations from the CCM UI
After loading an ALL file from the CCM, the camcorder will reboot.
After rebooting:
Always: Enables “ALL File” operations continuously.
Onetime: Enables “ALL File” operation once only, then the setting changes to “Off”.
Presets can be selected based on your use case.
For example, you can set [NCM Settings1] for XDCAM air and [NCM Settings2] for Network RX Station.