Sony VPL-VW85 Operating Instructions - Page 66

Message Lists, Message, Cause and Remedy, Symptom - clean air filter on projector

Get Sony VPL-VW85 - Bravia Sxrd 1080p Home Cinema Projector PDF manuals and user guides
UPC - 027242774346
View all Sony VPL-VW85 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 66 highlights

Symptom Cause and Remedy ON/STANDBY flashes in red. (A repetition rate of 5 times) c The lens protector is not fully open. Turn the power of the projector off and then on again. If the lens protector still does not fully open, consult with qualified Sony personnel. Tip In an urgent situation, refer to the illustration below to open the lens protector with your hands. Press the ?/1 (ON/STANDBY) switch to turn the power on and operate the projector. Note When a warning indicator other than the above starts flashing, and the symptom persists even after carrying out the above methods, consult with qualified Sony personnel. Message Lists Warning messages Message Cause and Remedy High temp.! Lamp off in 1 min. c Turn off the power. c Check to ensure that nothing is blocking the ventilation holes. (1 page 12) Frequency is out of range! c Frequency is out of range. Input a signal that is within the acceptable frequency range of the projector. (1 page 75) Please check Input-A Signal Sel. c Set "Input-A Signal Sel." in the Setup menu to "Computer" when an RGB signal is input from a computer. (1 page 53) Please replace the Lamp/ Filter. c It is time to replace the lamp. Replace the lamp. (1 page 68) c Also, replace the air filter too. Restart cleaning the ventilation holes (intake). (1 page 68) If this message appears again after you replace the lamp and filter, the lamp replacement process is not complete. Check the lamp replacement process. (1 page 68) Note To clear this message, press any button either on the remote control or the control panel of the projector once. 66

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
66
When a warning indicator other than the above starts flashing, and the symptom persists even after
carrying out the above methods, consult with qualified Sony personnel.
Warning messages
ON/STANDBY flashes in
red. (A repetition rate of 5
times)
c
The lens protector is not fully open. Turn the power of the
projector off and then on again. If the lens protector still does not
fully open, consult with qualified Sony personnel.
Tip
In an urgent situation, refer to the illustration below to open the lens
protector with your hands. Press the
?
/
1
(ON/STANDBY) switch to
turn the power on and operate the projector.
Note
Message Lists
Message
Cause and Remedy
High temp.! Lamp off in 1
min.
c
Turn off the power.
c
Check to ensure that nothing is blocking the ventilation holes.
(
1
page 12)
Frequency is out of range!
c
Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector. (
1
page 75)
Please check Input-A
Signal Sel.
c
Set “Input-A Signal Sel.” in the Setup
menu to
“Computer” when an RGB signal is input from a computer.
(
1
page 53)
Please replace the Lamp/
Filter.
c
It is time to replace the lamp. Replace the lamp. (
1
page 68)
c
Also, replace the air filter too. Restart cleaning the ventilation
holes (intake). (
1
page 68)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (
1
page 68)
To clear this message, press any button either on the remote control
or the control panel of the projector once.
Symptom
Cause and Remedy
Note