Stihl MS 441 C-M MAGNUM174 Product Instruction Manual - Page 24
Making Sapwood Cuts, D =Felling Cut, WARNING, E = Hinge
![]() |
View all Stihl MS 441 C-M MAGNUM174 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
English Making Sapwood Cuts D =Felling Cut E = Hinge E D D E 001BA150 KN 001BA144 KN 001BA145 KN N For medium sized or larger trees make cuts at both sides of the trunk, at same height as subsequent felling cut. N Cut to no more than width of guide bar. This is especially important in softwood in summer - it helps prevent sapwood splintering when the tree falls. Conventional and open-face technique: N Begin 1 to 2 inches (2,5 to 5 cm) higher than center of felling notch. N Cut horizontally towards the felling notch. N Leave approx.1/10 of diameter uncut. This is the hinge. N Do not cut through the hinge - you could lose control of the direction of the fall. Drive wedges into the felling cut where necessary to control the fall. N Helps control the falling tree. N Do not cut through the hinge - you could lose control of the direction of the fall. WARNING If the tip of the bar contacts a wedge, it may cause kickback. Wedges should be of wood or plastic - never steel, which can damage the chain. 22 MS 441 C-M
![](/manual_guide/products/stihl-ms-441-cm-magnum174-product-instruction-manual-b81ea49/24.png)