TASCAM DM-24 Installation and Use Automation Manual - Page 21
Write To End over previous Static fader position, Write To End over previous
View all TASCAM DM-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
4 - Operation Write To End: When the Write Revert Time is set to ∞s, you are essentially telling the automation system to maintain a control's last setting from the point where the automation recording ends, all the way to the end of the program. This is called Write To End. In this case, any mix moves existing in the time between the end of automation recording and the end of the program will be erased. NOTE A Write/Trim To End operation must be completed by stopping the time code. Manually disabling Write or Trim mode while time code is running will not perform a Write To End operation. AUTO REVERT must be enabled to use Write To End. See the diagrams below to understand how this works: Existing Static Fader Position 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -9 -12 Fader Movement Touch Fader Release Fader Figure 13 - Write To End over previous Static fader position Existing Fader Move Stop Time Code 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec +12 +6 +3 0 -3 -6 -9 -12 Fader Movement Touch Fader Release Fader Figure 14 - Write To End over previous Dynamic fader moves. 6 sec 7 sec 8 sec Stop Time Code TASCAM DM-24 Automation 21