TASCAM DM-24 Installation and Use Automation Manual - Page 30

4 - Operation Trim To End When the Trim Revert Time is set to ∞s, you are essentially telling the automation system to maintain the offset created by the trim operation from the point where trimming ends, all the way to the end of the program. NOTE A Write/Trim To End operation must be completed by stopping the time code. Manually disabling Write or Trim mode while time code is running will not perform a Write To End operation. See the diagrams below to understand how this works: Existing Fader Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -9 -12 Raise Fader & Release Figure 24 - Trimming fader moves with Trim To End enabled. Stop Time Code Existing POD Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -9 -12 Move POD & Release Figure 25 - Trimming POD moves with Trim To End enabled. 30 TASCAM DM-24 Automation Stop Time Code