TASCAM DM-24 Installation and Use Automation Manual - Page 27

4 - Operation Trimming Mix Moves There may be times when a control has existing mix moves that are good, but the overall level of those moves needs to be raised or lowered. In this case, Trim is used to offset existing moves. Action: Press the TRIM key before or after starting time code and its indicator lights. With time code running, perform the desired Trim operation. Result: With the console in Trim mode, any move- ment of a control while time code is running per- Revert Time: When a control stops trimming mix moves it "reverts" to reading any mix data that existed before trimming began. The previously existing data could be a dynamic mix move or a static control position. The amount of time it takes to move smoothly from forms a Trim operation on that control. The audio passing through the control reflects the previous mix moves, combined with the offset created by the Trim operation. In the case of the touch-sensitive faders, trimming begins when a fader is touched. In the case of POD controls, trimming begins when the control is moved. the end of the trimmed mix move to the previously existing data is called the Revert Time. A Revert Time is applied, even when the time code is stopped, past the point when the time code stops, to ensure a smooth transition between the trimmed mix move and the control's previous setting. TASCAM DM-24 Automation 27