TASCAM DM-24 Installation and Use Automation Manual - Page 28

4 - Operation Auto Revert Choices: With AUTO REVERT - TRIM enabled, the automation system stops trimming mix moves automatically per control without the need to stop trimming manually. In this case, controls stop trimming mix moves at different times, depending on when they were released (faders) or when movement ended (POD controls). In the case of the touch-sensitive faders, the revert starts when the fader is released. In the case of POD controls, revert starts when the CONTROL SENSE TIMEOUT has expired without movement of the con- trol. CONTROL SENSE TIMEOUT allows the POD controls to respond as if they are touch-sensitive even though they are not. When a Revert occurs, the control smoothly matches back to its previous data based on the amount of Revert Time set. That previous data could be a control's Static position or a control's Dynamic mix moves. See the diagrams below to understand how this works: Existing Fader Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Revert +6 Time +3 0 -3 -6 -9 -12 Raise Fader Hold Fader Figure 20 - Trimming fader moves with Auto Revert enabledl Existing POD Move Release Fader 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Revert +6 Time +3 0 -3 -6 Control -9 Sense -12 Timeout Move POD POD Movement Figure 21 - Trimming POD moves with Auto Revert enabled. 28 TASCAM DM-24 Automation Release POD