TASCAM DM-24 Installation and Use Automation Manual - Page 26

4 - Operation Write To End: When the Write Revert Time is set to ∞s, you are essentially telling the automation system to maintain that control's last setting from the point when automation recording ends, all the way to the end of the program. This is called Write To End. In this case, any switch events existing in the time between the end of automation recording and the end of the program will be erased. NOTE A Write/Trim To End operation must be completed by stopping the time code. Manually disabling Write or Trim mode while time code is running will not perform a Write To End operation. AUTO REVERT must be enabled to use Write To End. See the diagram below to understand this Write to End behavior: Existing Switch Events 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Switch ON Switch ON Switch ON +6 +3 0 -3 Switch OFF Switch OFF -6 -12 New Switch Events 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 Switch OFF -6 -9 -12 Resulting Switch Events 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Switch ON +6 +3 0 -3 Switch OFF -6 -9 -12 Stop Time Code Figure 19 - Writing a new switch event with Write To End enabled. 26 TASCAM DM-24 Automation