TASCAM DM-24 Installation and Use Automation Manual - Page 5

Setup

Get TASCAM DM-24 PDF manuals and user guides View all TASCAM DM-24 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

1 - Introduction Setup There are two possible sources of time code to which the DM-24's automation can lock. Both are equal in functionality and accuracy. Your choice will depend LTC There is an RCA jack (TIME CODE on the back of the DM-24 which accepts Linear Time Code (SMPTE/EBU). on what you have available in your situation. The choices are: To use LTC with the automation system, go to the SYNC/TC tab in the OPTION display, and then select TC IN as shown below: Figure 1 - OPTION / SYNC/TC display showing LTC choice MTC This refers to MIDI Time Code being received at the DM-24's MIDI Input. The source of MTC could be a Digital Audio Workstation (DAW), hardware recorder that does not support LTC, or any other source of MTC. To use MTC with the automation, go to the SYNC/TC tab in the OPTION display then select MIDI IN MTC as shown below. Figure 2 - OPTION / SYNC/TC display showing MTC choice TASCAM DM-24 Automation 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
1 – Introduction
TASCAM DM-24 Automation
5
Setup
There are two possible sources of time code to which
the DM-24’s automation can lock. Both are equal in
functionality and accuracy. Your choice will depend
on what you have available in your situation. The
choices are:
LTC
There is an RCA jack (TIME CODE on the back of
the DM-24 which accepts Linear Time Code
(SMPTE/EBU).
To use LTC with the automation system, go to the
SYNC/TC
tab in the
OPTION
display, and then select
TC
IN
as shown below:
Figure 1 – OPTION / SYNC/TC display showing LTC choice
MTC
This refers to MIDI Time Code being received at the
DM-24’s MIDI Input. The source of MTC could be a
Digital Audio Workstation (DAW), hardware
recorder that does not support LTC, or any other
source of MTC.
To use MTC with the automation, go to the
SYNC/TC
tab in the
OPTION
display then select
MIDI IN MTC
as
shown below.
Figure 2 – OPTION / SYNC/TC display showing MTC choice