TASCAM DM-24 Installation and Use Automation Manual - Page 24

4 - Operation Auto Revert Choices: With AUTO REVERT - WRITE/TRIM enabled, the automation system stops recording switch events automatically on a per control basis, without any need to end writing manually. In this case, keys stop recording switch events at different times, depending on when they were last pressed and depending on the value set in CONTROL SENSE TIMEOUT. In the case of control surface keys, writing ends when the CONTROL SENSE TIMEOUT has expired without a key press. CONTROL SENSE TIMEOUT allows the control surface keys to respond as if they are touch-sensitive, even though they are not. Writing switch events over a Static switch position simply adds the new switch events. When writing new switch events over previous ones, the DM-24 automation system provides you with a high degree of flexibility over when writing will end. See the diagram below to understand this behavior: Existing Switch Events 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Switch ON Switch ON +6 +3 0 -3 Switch OFF Switch OFF -6 -12 New Switch Events 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Switch ON +6 +3 0 -3 Switch OFF -6 -9 -12 Control Sense Timeout Resulting Switch Events 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Switch ON +6 +3 0 -3 Switch OFF -6 -9 -12 Control Sense Timeout Figure 17 - Writing new switch events over previous switch events with Auto Revert enabled. 24 TASCAM DM-24 Automation