TASCAM DM-24 Installation and Use v 2.0 Manual Addendum - Page 14
Circle and square patterns using the dial, Using the cursor keys, Jumping using the keypad
![]() |
View all TASCAM DM-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
DM-24 version 2.0-Release notes-Surround mode Circle and square patterns (using the dial) Note that you can now use the dial to set the position of the pan cursor in the surround screen, allowing for very easy 360-degree panning. The dial can be used to make diagonal moves, etc. (except when the cursor is highlighting the center channel percentage, as explained above) Select either a square or circle type pattern and a size. Now moving the dial will act as a surround pan control, moving the source around the pattern as selected in the SURROUND 2 screen. Using the cursor keys If you check the CURSOR MOVE box in the SURROUND 2 screen, you can use the cursor keys to move the pan cursor in the appropriate direction (holding down two keys together moves diagonally). Jumping using the keypad JUMP, as defined here, allows the 2ND F key to be used together with the number keys in the following way: 2ND F + 1 2 3 4 5 6 7 8 9 Result Rear left Rear center Rear right Left center Middle of the room Right center Left front Center Right front L-F C R-F + L-C Room R-C middle R-L R-C R-R Note that these moves can be automated. 14 TASCAM DM-24 2.0 release notes
![](/manual_guide/products/tascam-dm24-installation-use-v-20-manual-addendum-2d1a52e/14.png)