TASCAM DM-24 Installation and Use v 2.0 Manual Addendum - Page 22

DM-24 version 2.0-Release notes-Automation Automation Touch function The touch function is used to overwrite and erase POD, rotary encoder or switch moves. Since these controls are not touch-sensitive, this is a useful way to erase previous mix moves on these controls. The relationship between the previous mix moves and moves made using the touch function is shown below Existing Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Revert +6 Time +3 0 -3 -6 -9 -12 Press/Hold TOUCH & Move control Control Writing New Move To operate the touch function: 1 Enable Global Write mode. 2 Press and hold the TOUCH key and while holding it, operate the non touch-sensitive control (PODs, rotary encoders or switches) to begin writing or overwriting at the control's current value. While moving the con- Auto or Manual Revert trol, you can release the TOUCH key. Write mode is still enabled for this control. 3 Make a new mix move or end writing manually by pressing the REVERT key. If a new move is written, the revert action follows the settings made on the AUTO MAIN screen. UNDO (static) The UNDO key now can be used to undo adjustments made to a static control during a mix pass, as well as its previous "undo all mix moves" function. 22 TASCAM DM-24 2.0 release notes