TASCAM DM-24 Installation and Use v 2.0 Manual Addendum - Page 19

DM-24 version 2.0-Release notes-GPI functionality A port (defined in the SETUP part of the screen has to be selected for each event). Use the dial and ENTER key for this. Ports which have not been selected as time event ports produce a warning popup message. Choose a type, as for the key manual events (either a transition or a pulse). NOTE Note that the same port can output different types of event at different times. You should be careful when MIDI fader layer A new MIDI mixer layer has been added. Previously, the audio faders, mutes and pan controls could be assigned to any MIDI channel and controller number. While this capability has been retained, another MIDI layer with the same attributes that does not affect the audio faders has been added. This new MIDI mixer layer is set from the external control screen. When this is active, the mute keys, faders, and the soft panpots send out MIDI Control messages. setting up a sequence of events from the same port to make sure that there is no conflict or contradiction. The event types can be changed even when timecode is running. The events can be sorted by time (SORT TIME) or by port (SORT PORT) for easy checking. Individual events in the list can be deleted by highlighting them and using the on-screen DELETE button. And this one shows the mute settings:, The default setting is for DM-24 channels 1 through 16 to transmit on the corresponding MIDI channels, with the fader being controller 7, the pan controls (shown below) being controller 10 and the mute being controller 11. Use the MIDI CTRL.CHANGE screens to determine what messages are sent by each DM-24 control. This screen shows the faders and pan settings: NOTE The following MIDI controllers may not be assigned to DM-24 controls: 0, 6, 32, 38, and 96 through 127. Warning messages are shown if duplicate assignments are attempted. TASCAM DM-24 2.0 release notes 19