Thermador CIT36XWB Instructions for Use - Page 20

Deactivating Touch the cooking position display and select any power level in the settings area. The function has now been deactivated. Note: After 30 seconds, this function will automatically switch itself off. The cooking position will automatically switch back to power level 9.0. Keep Warm This function is suitable for melting chocolate or butter and for keeping food warm. Activating Select the relevant cooking position and then set the power level to ò.î « in the settings area. Deactivating Touch the cooking position display and select any power level in the settings area. The function has now been deactivated. Transfer function This function lets you transfer the selected power level or temperature setting and the cooking time from one cooking position to another. If you remove an item of cookware from the cooking surface or move it, the cooking position it was previously on stops heating. The settings for the cooking position will be retained for 30 seconds. When you place the cookware back in this position, the same settings will be used. Activation 1. Place an item of cookware on the cooking surface.   21O2)) 7,0(56 D $ The ˆ symbol will appear on the new cooking position. The settings have now been transferred to the new cooking position. Wireless Cooking Sensor Cooking Sensor mode ready (Wireless Cooking Sensor sold separately) You will need to connect the wireless cooking sensor to the cooktop before using Cooking Sensor mode for the first time. Preparing and caring for the wireless cooking sensor This section provides information on: ▯ Attaching the silicone patch ▯ Attaching the wireless cooking sensor ▯ Cleaning ▯ Changing the battery Silicone patches and cooking sensors can be purchased from the THERMADOR® eShop or by Customer Support. Order the relevant reference number: 00577921 Set of 5 silicone patches TCOOK- Cooking sensor and set of 5 silicone SENSW patches Gluing on the silicone patch The silicone patch secures the cooking sensor to the cookware. When using a piece of cookware with Cooking Sensor mode for the first time, the silicone patch must be attached directly to this piece of cookware. Proceed as follows: 1. The part of the cookware to which the patch is to be adhered must be free of grease. Clean the pan, dry it thoroughly and wipe the area where the patch is to be adhered with an all purpose degreasing agent. 2. Remove the protective film from the silicone patch. Adhere the silicone patch in the correct place on the outside of the pot using the supplied template as a guide.  21O2)) 7,0(56 2. Touch the ˆ symbol on the new cooking position to confirm transfer of the settings. The power level will light up.   21O2)) 7,0(56 D $ 3. Press down all over the surface of the silicone patch, including in the center. The adhesive requires 1 hour to fully cure. Do not use or clean the pot during this time. Notes ▯ Do not leave the pot with the silicone patch to soak in soapy water for long periods of time. 20