Thermador CIT36XWB Instructions for Use - Page 22
Replacing the battery, CAUTION, Declaration of Conformity, Class B digital device
View all Thermador CIT36XWB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
▯ Do not touch the sensor window with your fingers. This may make it dirty or scratch it. Replacing the battery If the cooking sensor does not light up when the symbol is pressed, the battery no longer has a charge. Replacing the battery: 1. Remove the silicone cover from the lower section of the cooking sensor casing and remove both screws using a screwdriver. 4. Put the silicone cover back on the lower section of the cooking sensor casing. 2. Open the cap on the cooking sensor. Remove the battery from the lower section of the casing and insert a new battery (make sure that the battery terminals (+/ -) are the right way round). 9 CAUTION Do not use metal objects to remove the battery. Do not touch the battery terminals. 3. Close the cap on the cooking sensor (the indentations for the screws on the cap must be aligned with the indentations on the lower section of the casing). Tighten the screws with a screwdriver. 22 Note: Use only high-quality CR2032 batteries in order to maintain a long service life. Declaration of Conformity The logos and the Bluetooth® brand are registered trademarks and property of Bluetooth SIG, Inc. These trademarks are used by BSH Home Appliances Corporation under license. All other trademarks and brand names are owned by the respective companies. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause interference, and 2. this device must accept any interference, including interference that may cause undesired operation of the device. Modifications not expressly approved by this company could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ▯ Reorient or relocate the receiving antenna. ▯ Increase the separation between the equipment and receiver.