Thermador HMWB36WS View Kitchen Design and Planning Guide - Page 21

PRO GRAND® PLANNING INFORMATION Professional Ranges Dual-Fuel: Thermador Pro Grand Dual-Fuel Ranges are dual rated, designed to be connected to either 240 / 208V AC, 60 Hz, 4-wire, single-phase power supply. The connection may be made with a range supply cord kit (purchased separately) or by hard-wiring to the power supply. A dedicated circuit breaker is required. Model PRD606WESG PRD606WEG PRD48WDSGU PRD48WISGU PRD486WDGU PRD486WIGU PRD364WDGU PRD366WGU PRD364WIGU Required Circuit Breaker 240 / 208V AC, 60Hz 50 A 50 A 50 A 50 A 50 A 50 A 30 A 30 A 50 A All-Gas: Thermador Pro Grand All-Gas Ranges are equipped with a 3-wire plug and are designed to be connected to a 120V AC, 60 Hz, single-phase power supply. A dedicated circuit breaker is required. Model PRG486WDG PRG364WDG PRG366WG Required Circuit Breaker 120V AC, 60 Hz 20 A 20 A 15 A Electrical Supply IMPORTANT: The cord supplied with gas ranges having an electric griddle requires a NEMA 5-20 receptacle as shown here. Local codes my require a different wiring method. NEMA 5-20 RECEPTACLE PLUG WARNING: This appliance is equipped with a three-prong grounding plug for protection against shock hazard and should be plugged directly into a properly grounded receptacle. DO NOT cut or remove the grounding prong from this plug. DO NOT ALTER THIS PLUG. Electrical and Gas Locations Typical placement of the electrical and gas supply can be found within the "Cutout and Range Dimensions" located on the installation pages. Alternate placement within the supply zone is acceptable. Dual-Fuel ranges may be connected to the power supply with a range supply cord kit (sold separately) or by hard-wiring to the power supply. Allgas ranges may be connected to the power supply with the supplied range cord or by hard-wiring. It is the responsibility of the installer to provide the proper wiring components (cord or conduit and wires) and complete the electrical connection as dictated by local codes and ordinances and/or the National Electric Code. The units must be properly grounded. Installation of the range must be planned so that the rough-in of the junction box for the receptacle or conduit connection will allow maximum clearance to the rear of the unit. PRO GRAND® INSTALLATION Professional Ranges 60-Inch Range Dimensions 48-Inch Range Dimensions 36-Inch Range Dimensions Range Cutout Dimensions inches (mm) 30", 36", 48", 60" (762, 914, 1219, 1524) C A D CL E X B CL 8" (203) X Range model All Harmony series 36''/ 48'' Grand series 60'' Grand series Gas zone A 4'' (102) 4'' (102) 4'' (102) Electric zone B 6'' (152) 6'' (152) 6'' (152) X 5'' (127) 8'' (203) 8'' (203) C N/A 4'' (102) 4'' (102) D N/A 3'' (76) 3'' (76) E 2'' (51) 2'' (51) 1'' (25) | THERMADOR | RANGES | THERMADOR | RANGES 38 Visit Thermador.com for complete specifications or text a Thermador model number to 21432 to have specs sent to your phone Visit Thermador.com for complete specifications or text a Thermador model number to 21432 to have specs sent to your phone 39