Thermador HMWB36WS View Kitchen Design and Planning Guide - Page 72
Downdraft, Hoods
View all Thermador HMWB36WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
| THERMADOR | VENTILATION | THERMADOR | VENTILATION DOWNDRAFT HOODS ACCESSORIES Recirculation Kit Use with induction / electric cooktops only UCVRECIRC Downdraft Gas Cooktop Seal Trim Kits Required for installation with Gas Cooktops UCV36ST - 37-Inch Replacement Charcoal Filter UCVFILTER 25 ft. Blower Connector Cable For use with the following inline and remote blowers: VTI1FZ, VTI2FZ, VTR1FZ, VTR2FZ Cannot be connected together to extend length. EXTNCB25W 5 ft. Electrical Panel Extension Cable This cable extends 5 ft. to move the electrical panel out of the way to offer full installation flexibility in any ducting scenario while installing the downdraft. Ability to connect two cables together to make a 10 ft. cable. Cannot be used to connect inline or remote blowers. EXTNCE5 UCV30ST - 30-Inch Remote and Inline Blower Downdraft Transitions CVTSIDE6 CVTSIDE8 CVTSIDE10 CVTFRONT6 CVTFRONT8 CVTFRONT10 CVDUCT2 CVTRECT2 6" Side / Rear Transition 8" Side / Rear Transition 10" Side / Rear Transition 6" Round Front Plate 8" Round Front Plate 10" Round Front Plate 2' Rectangular Duct Transition for Rectangular Duct Lighting SKU UCVP36XS Included Yes Bulb Type LED Strip 140 Visit Thermador.com for complete specifications or text a Thermador model number to 21432 to have specs sent to your phone DOWNDRAFT HOODS ACCESSORIES CVTSIDE6 6" round transition allows for left, right, or rear venting. Use with inline and remote blowers, and ducting with 6" round duct connections. CVTSIDE8 8" round transition allows for left, right, or rear or downward venting. Use with VTD600P blower as an inline installation, and ducting with 8" round duct connections. CVTSIDE10 10" round transition allows for left, right, or rear venting. Use with inline and remote blowers, and ducting with 10" round duct connections. CVDUCT2 Rectangular 2 ft. long x 1 7/8 in deep x 19 in wide duct. CVDUCT2 transition required to directly connect CVDUCT2 to sides or rear of downdraft housing. Can be used as an extension to exhaust through a cabinet or wall, and can be cut to modify length. For use with installation of inline or remote blower applications with CVTSIDE6, CVTSIDE8, and CVTSIDE10. CVTFRONT6 6" front rough-in plate allows for front venting. Use with inline and remote blowers, and ducting with 6" round duct connections. CVTFRONT8 8" round front plate allows for front downward venting. Use with VTD600P blower as an inline installation, and ducting with 8" round duct connections. CVTFRONT10 10" front rough-in plate allows for front venting. Use with inline and remote blowers, and ducting with 10" round duct connections. CVTRECT2 Transition required to connect CVDUCT2 rectangular duct to downdraft housing at left, right, or rear. 141