Thermador HMWB36WS View Kitchen Design and Planning Guide - Page 47
Warming Drawer and Storage Drawer
View all Thermador HMWB36WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
| THERMADOR | BUILT-IN MICROWAVES & DRAWERS | THERMADOR | BUILT-IN MICROWAVES & DRAWERS PLANNING INFORMATION Warming & Storage Drawers Model Options Thermador 30-inch Warming Drawers are available in a push-to-open design with a stainless front or a Custom Panel design. These drawers pair beautifully with a Thermador speed oven or microwave. Thermador 30-inch Storage Drawers are available in a standard or short design. The short design pairs perfectly with a Thermador steam and convection oven. Be sure to reference the correct model information in this design guide. Installation Considerations The information in this design guide provides key features, product dimensions, cutouts and installation specifications. Before installing a Thermador Warming Drawer or Storage Drawer, be sure to verify the cabinet dimensions and electrical connections (if required). Installation instructions are subject to change. Always consult with the installation manual included with the product for complete details prior to the installation. Electrical Specifications Be sure your appliance is properly installed and grounded by a qualified technician. Installation, electrical connections and grounding must comply with all applicable local codes. All Thermador Warming Drawers are designed to be connected to a 120V AC, 60 Hz, 3-wire, grounded outlet with a 15 A circuit breaker. Electrical Location The outlet can be installed in the back wall directly behind the drawer. A recessed power receptacle must not exceed 5 1/2 ft. (1.7 m) maximum distance from either side of the warming drawer cutout. Installation clearances permit for the excess power cord to be coiled behind the appliance. Custom Front Panel The Thermador Custom Panel Warming Drawer requires a custom front panel. You may build a custom drawer front panel to coordinate with your cabinetry. Custom panels must meet the following requirements: • Have a handle • Have the dimensions shown below • Have a minimum thickness of 3/4" (19 mm) • Have all edges finished • If using wood, the back must be sealed to prevent moisture damage • Be capable of withstanding a temperature of 158°F (70° C) Installation Options Wall-Mounted Installation Thermador Warming Drawers may be installed below any Thermador Single or Double Built-in Oven. A minimum space of 1" (25.4 mm) is recommended between the bottom of the oven and the top of the warming drawer. Under-Counter Installation Thermador Warming Drawers may also be installed below any Thermador Electric or Non-professional Gas Cooktop as long as there is not contact between the bottom of the cooktop and the top of the warming drawer. When installing below a Thermador Induction Cooktop, a minimum 1" (25.4 mm) air gap must be maintained between the bottom of the cooktop and the top of the warming drawer. When installing below a Thermador Professional Rangetop, a minimum 2 3/4" (70 mm) air gap must be maintained between the bottom of the rangetop and the top of the warming drawer. The cabinet base must be flat and capable of supporting a weight of at least 110 lbs. (50 kg). Side-by-Side Installation Thermador Warming Drawers and Storage Drawers may be installed side-by-side in combination with a single wall oven. Accessory kit TWO30YS may be required. See page 77 for details on approved combinations for side-by-side installation. INSTALLATION Warming & Storage Drawers Custom Panel Warming Drawer WD30W Warming Drawer and Storage Drawer WD30WC and SD30WC Flush Installation WD30W, WD30WC or SD30WC 90 Visit Thermador.com for complete specifications or text a Thermador model number to 21432 to have specs sent to your phone Cutout Dimensions WD30W, WD30WC and SD30WC 91