Thermador PRG366WG Instructions for Use - Page 55
Before calling for service
View all Thermador PRG366WG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Before calling for service Before calling for service, check the following to avoid unnecessary service charges. Troubleshooting Symptom Possible cause Remedy Intermittent igniter sparking • Ceramic igniter is wet or dirty. • Carefully dry or clean igniter. • Burner ports are clogged. • Clean ports on burner cap with a wire, a needle or straightened paper clip. More than four clicks of igniter before lighting • Improper fit of burner cap onto burner base. • Align burner cap properly on burner base. Constant igniter sparking • Range is not properly grounded. • Refer to the Installation Instructions. • Electrical power supply is incorrectly Have a qualified electrician ground the polarized. range properly. Igniters sparking but no flame ignition. • Gas supply valve is in "OFF" position. • Restore gas supply to the unit. Range will not operate (lights, oven, and surface burners will not come on) • No power to the unit. • Check for open circuit breaker. • Check that power supply line connection is connected to the proper voltage. • Oven is in Sabbath mode. • Verify that the oven is not in sabbath mode. See the ''Using the oven'' section of the Use and Care Guide. Oven operates on bake but • Timer improperly set. fails to operate on timed bake • Set timer as outlined in the Use and Care Guide. Oven light fails to come on. • Oven light burned out. • Replace the oven light as outlined in the Use and Care Guide. Door will not open. • Oven is still in self-clean mode. • If oven is hot, door latch will release when safe temperature is reached. Foods in oven are not cooking sufficiently. • Rack position is incorrect. • See the ''Using the oven'' section of the Use and Care Guide. • Improper cookware. • Refer to ''Cookware recommendations'' in the Use and Care Guide. • Oven door may not be sealing properly. • Clean the oven door gasket. Replace if worn. • Appliance not level. • Refer to the Installation Instructions for instructions on how to level the appliance. Hot air is coming from the appliance. • It is normal for the cooling process to • This is normal. push heated air out into the room when the oven is on. • During different modes the fan speed will increase and decrease. Page. 54