Toshiba 52HMX95 Owner's Manual - English - Page 22

Chapter 2: Connecting your TV Connecting a device to the TheaterNet OUT infrared terminal using the IR blaster cable for IR pass-through device control You can use the TV's TheaterNet OUT* infrared terminal (IR pass-through) to remotely operate-through the TV-many infrared remote-controlled devices (such as Toshiba infrared remote-controlled VCRs or DVD players) enclosed within an entertainment center or similar cabinet. Without the TheaterNet OUT connection, the device typically would need to be visible to operate it remotely. You will need: one dual-wand IR blaster cable (included with your TV) other audio/video cables as required to connect the device(s) to the TV (see pages 15-21) To connect the IR blaster cable: 1. Locate the infrared sensor on the front of your device. This sensor is marked on some devices.** 2. Align one of the IR blaster cable's wands about 1 inch away from the infrared sensor on the front of the device and attach it using double-sided mounting tape. If you have a second device, attach the second wand in a similar manner. (See illustration at right.) Note: If you do not have a second device, coil the second wand with a rubber band and leave it behind the TV. 3. Plug the IR blaster cable's plug into one of the TV's TheaterNet OUT terminals. To control the device(s): Point the TV remote control (that you previously programmed to operate the device; see Chapter 3) or the device's remote control at the front of the TV and press the button for the desired function. TV/VIDEO EXIT CHANNEL VOLUME MENU POWER The signal passes from the remote control through the TV to the device via the IR blaster cable. Note: • If you use the device's remote control to operate the device, you also will need to use the TV's remote control to operate the TV. • For additional control options, see "TheaterNet on-screen device control" on the next page. Front of IR-controlled DVD player (for example) Front of IR-controlled audio device (for example) Infrared sensor IR blaster cable wand (approx. 1 inch from device) Back of TV **If you cannot locate the device's infrared sensor: 1. Turn OFF the device. 2. Starting at the lower left corner of the device, place the end of the device's remote control (with the infrared emitter) so it touches the front of the device and press POWER. (Do not use the TV's remote control for this step.) 3. If the device turns on, the point at which the remote control touched the device is the location of the sensor. 4. If the device does not turn on, move the remote control slightly to the right and press POWER again. 5. Repeat step 4 until you locate the device's infrared sensor. The TheaterNet OUT function has been verified for use with Toshiba infrared-controlled devices. 22 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.