Toshiba 52HMX95 Owner's Manual - English - Page 57

Chapter 6: Setting up your TV Viewing the digital signal meter Viewing the system status You can view the digital signal meter for the ANT 1 and ANT 2 digital TV input sources only. To view the digital signal meter: 1. Press MENU and open the Setup menu. 2. Highlight Installation and press ENTER. To view the system status: 1. Press MENU and open the Setup menu. 2. Highlight Installation and press ENTER. A new set of Installation menu icons will appear on-screen, as shown below right. Setup Installation Sleep Timer On/Off Timer PC Settings HDMI 1 Audio HDMI 2 Audio Slide Show Interval Auto Auto 2 Sec Navigate Select CH RTN Back EXIT Exit 3. A new set of Installation menu icons will appear on-screen, as shown below. Open the Terrestrial menu, highlight Signal Meter, and press ENTER. Terrestrial Input Configuration Channel program Channel Add/Delete Signal Meter Navigate Select CH RTN Back EXIT Exit 4. Press yzx • to select the antenna input and digital channel whose signal you want to check. Note: The physical digital channel number listed in the Signal Meter screen may not correspond to a virtual TV channel number. Contact your local broadcasters to obtain the RF channel numbers for your local digital stations. Signal Meter Signal Locked 0 Peak 0 Antenna 1 Physical Digital Channel 13 Virtual Digital Channel N/A Done To close the screen and return to the Terrestrial menu: Highlight Done and press ENTER. To return to normal viewing: Press EXIT. Setup Installation Sleep Timer On/Off Timer PC Settings HDMI 1 Audio HDMI 2 Audio Slide Show Interval Auto Auto 2 Sec Navigate Select CH RTN Back EXIT Exit System Status System Infomation Navigate Select CH RTN Back EXIT Exit 3. Open the System Status menu, highlight System Information, and then press ENTER. 4. Press x • to scroll through the menu bar to check the Product Information and Software Version. System Information System Information Product Information Brand: Model: IEEE1394 GUID: Toshiba 52HMX95 00003914-28343803 Software Version 0.3.0 Mar 9 2005 - 12:37:10 FW:0.12 Sub:47 Done Done To close the screen and return to the Installation menu: Highlight Done and press ENTER. To return to normal viewing: Press EXIT. Restore Factory Defaults To restore all settings and channels to their factory default values: 1. Follow steps 1-3 above. 2. Press x • to scroll through the menu bar to select Factory Defaults. 3. Enter your PIN code (or 0000 if no PIN code has been set). 4. Highlight Yes and press ENTER. The TV will turn off automatically after a few seconds. After the TV turns off, unplug the TV power cord and then plug it in again to complete the restore process. System Information Press YES to confirm. After the TV turns off, unplug it and plug it dack in to complete the reset. Yes No To cancel the reset: Highlight No and press ENTER. Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 57