Toshiba Portege M500 PPM51C-GF201EF Users Manual Canada; English - Page 228

AT Commands Nn Modulation handshake This command controls whether or not the local modem performs a negotiated handshake at connection time with the remote modem when the communication speed of the two modems is different. N0 When originating or answering, this is for handshake only at the communication standard specified by S37 and the ATB command. N1 When originating or answering, begin the handshake at the communication standard specified by S37 and the ATB command (default). During handshake, a lower transmission speed may be selected. Result Codes: OK n=0,1 ERROR Otherwise On Return on-line to data mode O0 Instructs the modem to exit on-line command mode and return to data mode (see AT escape sequence, +++). O1 This command issues a retrain before returning to on-line data mode. O3 This command issues a rate renegotiation before returning to on-line data mode. Result Codes: OK n=0,1,3 ERROR Otherwise P Select pulse dialing This command configures the modem for pulse (non touch-tone) dialing. Dialed digits are pulsed until a T command or dial modifier is received. Tone dial is the default setting. Qn Result code control Result codes are informational messages sent from the modem and displayed on your monitor. Basic result codes are OK, CONNECT, RING, NO CARRIER, and ERROR. The ATQ command allows the user to turn result codes on or off. Q0 Enables modem to send result codes to the computer (default). Q1 Disables modem from sending result codes to the computer. Result Codes: OK n=0,1 ERROR Otherwise C-4 User's Manual